Trend CraftPro Straight Two Flute Router Cutter Bit, 1/4 Inch Shank, 12mm Cut Diameter & 19.1mm Cut Length, Tungsten Carbide Tipped, C019X1/4TC

This is one of the best router bits I have bought. Beautifully engineered, strong shoulders on the shank, and very sharp. With 2 flutes instead of just 1, it cuts very easily without vibration and no irregularities to ter the wood. I have found it excellent with both hard woods and pine. All round, an excellent bit.

Brilliant sharp bit. Delivered with ease.

Good quality sharp cut

Great for the money. I use these on an 8x4 cnc machine cutting 15mm veneered ply. I can cut around 20 sheets before they get noisy. Have tried more expensive ones and they last about the same. These are my go to and have been for 8 years.

Works well and give a good finish on hard and soft wood.

good purchase not used yet but looks good quality

Good cutter, cuts well.

Got a collection of different router bits from trend and this one was oriented with section for holding collet at the top, rather than at the bottom, strongly suggesting someone had messed about with this (sadly this one arrived first and the remainder later so it wasn't that immediately obvious).. Once I noticed this I spotted a minor blade defect mid blade and scratches near where cutter is held by router. I was wondering if this was trend dodgy qc but none of the other cutters had this issue (and 3 are in the same range) show any of the same signs. Spotted this too late for this time but I would suggest caution when accepting these in future - don't leave it as long as I did before inspecting the blade.