Partsam 2Pcs 4.4" Amber 24 LED Turn Signal Side Marker Lights [DOT Approved], IP67 Waterproof Amber Lens Aluminum Housing Surface Mount Marker Lights for Trailer Truck Tractor RV

Extremely well build lights that are very bright. I used them for the front blinkers for an after market blinker kit that I installed in my 2016 Can-am Defender HD8 XT side-by-side. Not only do they look much better than the small 3/4” round lights that were included in the kit, they are much brighter and more visible. They were very easy to install and look great. I was very impressed with how well these lights are made, heavy duty metal frame and inclosed housing and, they put out a very bright light.

Finally, a run/turn/brake LED module with a significantly brighter brake/turn function vs run. Only thing that would make it better is a fully flat rear, with wires exiting out the side. Does require drilling for the slight prutrusion where the wires exit from the center of the back. Or, a spacer block with grooves to run the wires to the sides. Well constructed aluminum housing with red lens and LEDs. Good level low intensity for running lights and much brighter brake/turn lights. Would definitely buy again.

Light worked great for back up lights on work truck

I'm adding these to the inside of my truck bed, to help light it up. I own a 2020 Chevy 2500HD, and they have 2 built in the back of the bed shining forward. Ok, that's fine, but I want more light. These are pretty perfect for the job. These have an aluminum body, not plastic. The lens is stated to be poly carbonate, we'll see. These come with a plastic rubber gasket thingy....not the best, but with blk silicon, works fine. The hole size works best with a #6 screw, and I used blue Loctite on the treads. I bolted these in, not screwed in. I worry about vibration. Wiring these is a bit confusing if you didn't read the wire code in the description. WHITE is GROUND. RED is HIGH PWR. BLACK is LOW PWR, so dimmer. The wire is tipped tinned, but copper 18awg. These pull hardly any power, so I just connected into the current bed light power supply, and used too much stuff to list, but it's for future replacement needs. I sealed up the back of the wiring with sealant, and ran a bead around the outer edge to prevent leakage. Pro tip. Use a nail polish on the drilled hole in whatever you drill in. It dries fast, and will be as thick as needed to prevent rust behind these lights. Overall I like them, not super bright, but lights up well with the oem ones.

Very small, but super bright. Nice to have aluminum and not plastic. Very well built. Exactly what I needed

Work great for my retrofit project. Easy to install and more bright then factory.

I purchased these to rewire a 78 Ford pickup bed trailer I used mostly for firewood. The original system had failed. I added new wiring and mounted these to the original taillights. Install was easy just remember each one needs the white wire grounded to the trailer frame and the wire near the plug as well. Took me a bit to figure out. I tried to run them all together and it didn't work. These lights are super bright and no more changing 1157 bulbs. Super pleased. These should work for a long time.

Good very bright they been holding up no burn or water in it yet

Easy to hook up with 12 V adapter. Excellent brightest for accent lighting.

Très belle éclairage

Needed to replace the lame single diode LED lights on my four year old Bailey Rangefinder caravan, which were failing one-by-one. These were easy to install, and plenty bright even on the lower brightness setting.

I replaced the tail lights on a small trailer with these. Nice and bright for both turn/stop and tail lights.

I needed a brake light on the back of my camper. I installed the pair side by side and now have a very bright light to warn drivers behind me.