120uf 250 Volt

Looks like they're going to work perfect for my phase correction capacitors. Polypropylene is suggested because of its longer lasting and being able to use as a run capacitor not just a start capacitor. The stud on the bottom enables it to be mounted with a hole on a flat plate.

Excellent Start-Run motor capacitor. A near-perfect fit and 3/4 HP 120VAC motor now starts and run perfectly. Capacitor is as advertised.

Was delivered on time works well no issues. Only had to drill contacts because my setup uses nuts and screws and not push on connectors. Wasn't wasting the extra time putting those on

Bought the 25 uf 450v capacitor to replace a 300v capacitor in my Ryobi BHG bench grinder. The original 300v capacitor was no longer made and this one was a little bit larger. The new capacitor was able to fit in the same space. Started on the first switch on. Very pleased. Took 15 minutes to replace. Don't no how long it will last, for the low price, but for now I recommend.

Did the trick as a replacement for my bandsaw motor. Only downside is the size. Too large to fit under the cover. Cable ties around the motor to hold it in place.

Keep one of these on hand just in case either of my refrigerators has one go out.

Got this for my ge washer. Works perfectly. Washer was fixed and back into action

Worked great for repairing my bench grinder. Directly replacement.

Unit fit exactly into original position with the stud and nut on the end , had to clip the wires and change terminal ends , compressor starts and runs perfectly again .

mon compresseur mastercraft 8 gallons fonctionne a nouveau

Worked great on my Signal portable air compresser. Only had to cut the factory eye terminals off complesser an instal heat shrink femal spade connectors to conect the 2 wires. It back up an running. Oh an the attached stud screwed right in.

worked perfect on my dewalt compressor

Apart from color, it was a perfect replacement for the original part, worked as it should