4 Pack - 10mm Round Shaft Central Door Lock Actuator Motor FC-280PC-22125, Spindle, Power Locking Repair Engine

These were a direct replacement for my oem actuator motors. Getting the actuator assembly out wasn't an issue, as well as separating the two halves of the actuator. The biggest problem was getting the little pinion that was pressed into the motor shaft. I had to sacrifice one motor to hammer the other 2 out. After that, these bad boys fit perfectly and works flawlessly. My 2 door locks finally work! They've been broken since day 1 I bought it.

I used 2 of these (so far) to replace those in two two power door locks in my Toyota vehicle. They were only slightly different in visible characteristics from the factory originals. As I expected, they were a devil to install. But they fixed the problem, and the power locks are now working. They saved me most of $500 as compared with the best price that I could find for the only replacement parts that Toyota seems to provide --- in the form of the complete lock assembly extending from what you see on the end/edge of the door to the connecting points at the levers on the inside of the door panel. And that would not have included any installation cost to have the dealer do the work!

Ordered the 4-pack. One was dead, the other 3 would spin backwards, so would unlock the car when trying to lock and would lock when trying to lock. And easily falls apart. It did fit, so if they were working (not dead or reversed spinning) I'd accept the fragile-ness for the price.

This product was used on a Land Cruiser 2001 100 series with one small issue which I manage to overtake. The shaft on this motor is round all the way and the original motors on this vehicle are half-round. However, I manage to work it out by using my small file and grind the motor shaft to make it looks similar to the original one and it works just fine, I have to hold the motor shaft with Locking Pliers from one end and grind the other end to prevent the shaft of turning while filing. The motor works fine and it looks strong with the first few tests, however will update my review if the motors fail/ does not last longer.

Bought to fix the notorious gs300 door lock actuator issue. I figured this is a better fix than buying the super cheap actuators that wig out after a week. Fit great into the factory actuators. Will need a tiny gear puller. Super cheap cost for a big fix too. Now I have working door locks again.

Great working good

These are exact replacements for the Lexus GS 300 model. Made my door locks work like new again! You need the small gear puller to remove the drive part from the old motor shaft (Walkera or equivalent). Press it back on to the new shaft with a vice. Hard part is separating the door actuator case. I used a safety razor blade (hw store variety) and a small hammer to gently tap the razor blade between the two halves of the case all around the perimeter of the case. Getting the actuators out of the door is not hard, but requires patience. Good videos and write ups on how to do this on the Internet.

Really not a 1star for quility etc. Just wanted to get attention so people looking to get these motors for a Lexus door repair do not buy these. These are not D shafts and will not work.