SINGARO Car Rear Bumper Protector, 42inch x3.4inch Car/SUV Universal Rubber Anti-Scratch Trunk Exterior Accessories

Awesome product! Used acetone to clean top of rear bumper. Cut with scissors and razor knife . Great product and fit. Looks factory installed. 30 minutes to install. Can’t beat the price ! Weather tech wanted $50.00 plus shipping. These once again are awesome!

This was a great fit for my 2025 Subaru Forester...once I trimmed it. The product is well made, thick, and of a nice quality. It doesn't come with installation instructions, which I think it should, but was easy enough to figure out. Just make sure your bumper is very clean and dry before applying. I used some rubbing alcohol to prep the area. It was fine on the length, but the width was a little too large for my vehicle. It's very easy to trim along the guidelines with sharp scissors. I chose to trim off one section on the edge that was on the exterior side of the bumper (as it would be the shorter side of the length). The nice thing is that the plastic liner peels off in 4 sections, which makes it easier to apply. After locating the center of the bumper, I aligned the product on the bumper matching center to center. I then used some painter's tape to hold down the left side so that it wouldn't move during installation. Then I removed the liner from the center right side and slowly applied the mat to the bumper from the center towards the right and then repeated with the next section of liner on the outer right section. The process of taping down the left half while applying the right half allowed for no movement during installation of the right side. I then removed the left side of the liner in the same order as the right and smoothed it down with a towel to remove any possible bubbles. It was a perfect installation.

This fit great on my 2023 Grand Cherokee. I had to cut it with some scissors, but no big deal. It looks great! Very easy to install, and also at a great price point.

Good quality, not a perfect fit for my escape. Universal maybe, but not ideal for all.

It was easy to install. Laid it out to flatten itself overnight and it molded to the bumper easily. The full coverage of the adhesive makes me think it will stay down well. After installing, I rubbed it down with a roller, just to be sure. This was installed on a 2023 Land Rover Defender 110.

My Crosstrek bumper already had a couple of scuffs after a month, so I decided to give this a try. It was easy to install and the fit was great on the Crosstrek. Looks pretty good and no trimming needed. I installed it on a day that was about 40F, and it adhered well. It has since held up through freezing temperatures. There hasn't been any hot days yet to evaluate heat tolerance sin I installed it, but I will update if there are any issues..

Product seems satisfactory at first, but over a couple weeks of use, the adhesive is flowing out from under the product. Will return item, but getting it off the bumper is going to be a messy job.

It comes somewhat larger than needed, but it's easy enough to cut. Just be careful that you get nice, clean cuts, or it'll look pretty bad with ragged edges. It's a good non-slip surface, and the adhesive backing is great as long as you get a good, clean surface to adhere it to. It should provide some good protection to my bumper, and it looks pretty neat. It comes rolled up tightly, so you'll probably want to lay it out flat for a while to make it easier to work with.

Já vem com adesivo

Buen producto y llegó a tiempo

Very easy to install, fits perfectly on my 2024 Subaru Crosstrek.

This is a high quality rubber trim strip. Apply it carefully and it will look like factory. Protect you bumper. Highly recommended

Llegaron muy bien y están de muy buena calidad