Thermalright Heilos Solid Thermal Interface Sheet, Solid Thermal Conductive Silicone Grease Sheet for CPU/GPU, Conductivity 8.5W/mk, Desktop/Laptops General Purpose,for Intel (30×40×0.2mm)

İ9 14900HX işlemcili laptopumu resmen dizginledi. Bu kadar beklemiyordum. Doğru uygulanması önemli, uygularken dikkat edin.

The thermal paste wouldn't separate cleanly from the paper it comes on, so it couldn't be used.

Performance - Using a 13900k @ 290w with a corsair H115i (280mm radiator) & a thermalright contact frame. Moving from stock corsair thermal paste to this pad decreased cinebench temps from ~93c to ~90c. For thermal paste, a 3c difference is pretty impressive. The 13900k will always run hot, but this pad gives you some extra breathing room. Installation - Not fun. Pad is thin, and strongly adheres to plastic. I froze the pad before installation (less chance of ripping) & used a hair dryer to melt the pad a bit after applying it (to remove second plastic piece). Expect this part to take some time and frustration. Notes - Based on packing materials that mention "phase change temp", I am assuming this is rebranded ptm 7950. Most other ptm 7950 listing cost more, and come with a degree of uncertain authenticity. As thermalright is a legitimate company, this seem to be the cheapest and most reliable way to acquire this type of thermal paste. As to its performance, ptm 7950 is still pretty new in the pc building space, but early adopters report that performance improves over time, with some listing reporting 1000 curing cycles to reach max thermal conductivity. I've only been using the pad for about 2 weeks, so I can't vouch for the long term performance yet.

Used it on my GPU die and motherboard chipset dies to bring down temps. GPU had a major difference as I think the thermal paste that came from the factory had started to give/pump out or something. Reduced my temps from very high hot spots on my 7900XTX to reasonable hot spots. Chipset die I'm not sure how much it did but I think the fan on the x570 chipset is a bit more calm now. I did have issues with getting it to stick and come off the plastic but even if it breaks as long as you get everything covered when it heats up it should liquefy and hopefully be ok as long as no air bubbles.

Put it in freezer (not fridge) for 15 minutes and then use it. Or else it’ll just not stick. Temps are higher than before (educated guess, didn’t benchmark before) but that’s to be expected, takes 10-15 thermal cycles to reach its full potential so benchmark with furmark. Surprisingly , temps drop faster after getting out of apps.