DC 12V/24V to 5V USB C Step Down Converter Type-C Interface 5A 25W Waterproof Buck Module Power Adapter Compatible with Raspberry Pi 4, Cell Phones 1-Pack

I had put a USB port in my truck. Then I plugged my windshield camera into it. It lasted a day and stopped working. I realized that the camera didn't take 12V DC it was supposed to run on 5V DC and burned up. I got this and wired it into my fuse box (with another connector I got off Amazon) and run it straight to my new camera. Then you can run the cables cleanly into headliner seeing how it doesn't connect to a USB port in front where everyone can see. Highly recommend!

One of the few 12V to 5V 5A USB-C adapters that work with the Raspberry Pi 5! No low power warnings! The Raspberry Pi 5 USB type C power connector uses USB type C Power Delivery communication to negotiate the higher 5 amperes at 5.1 volts, which is per PD standard 3.0, but higher than the normal 3 amperes specified in the type C standard. Without negotiating 5 ampere Power Delivery, the Raspberry Pi 5 USB ports are limited to 0.6A, instead of a total of 1.6A. from all four ports. The Raspberry Pi 5 mains wall wart supports this, but I have been searching for a direct 12 volt adapter, to avoid the clutter of an inverter-wall wart combo. I have tried a lot of other brand 12 volt to type C PD adapters and they failed the higher current negotiation. This adapter module WORKS if you add this line to the end of /boot/firmware/config.txt: usb_max_current_enable=1 This makes the Pi5 assume that the PSU is capable of delivering the full 5 Amps if/when needed, and ignore the PD negotiation.

Item arrived new. I will use it with a small motorbike battery and drip-charger for power-out use. :)

failed after 15 months permanent short inside the epoxy for red and black wire. puff of nasty smelling smoke and blows fuse. lived in extreme conditions so i dont fault it, was nice when it worked. Your locked to USB-C as the output but i see it as a plus, dont have to solder that bit on. Just bear that in mind when you buy this. Also this wont tell the RaspberryPi5 that it can use "big power mode". But you can safely tell the pi in raspi-config to ignore the limits and just pull what it can. I can power a touchscreen, usb3 stick and the pi5 with an active cooler all on this thing with no issue. Don't really feel any heat coming from it, and its an epoxy build so its going to have good water resistance and strength. Of course don't submerge.. the way the cables come out the epoxy means its not 100% water tight. 12v-24v input means car usage is solid. still going strong 3 months now. Powering pi5 with active cooler, a usb wifi adapter, usb soundcard, and usb rca camera dongle, & usb touch screen.

This is great! I use this to essentially hard-wire a Raspberry Pi into a 12V camera system. It's current appears to be stable, and the USB-C plug works perfectly to power a Pi.

not enough amperage to maintain a eero 6 router, probably be ok for slow charging devices..

Perfect solution when you only have 12V DC and need to power a USB 5V device. I have bought a few for projects and have been working almost a year without issues 24/7.

Greatly simplified the installation of my new dash cam. Fit nicely into the housing at the base of the rear view mirror.

I bought 5 of these to use with Raspberry Pi 5 and they work well.

Je l'utilise pour alimenter un petit travel router, fonctionne bien