Hoypeyfiy Carburetor with 2 Gaskets, Compatible with Subaru Robin EX13 EX17 EX17D SP17 SP170 Small Engines, Replaces 277-62301-30 277-62301-50

Bought for my Generac power washer that had a seized emulsion tube in the carb. Always weary of aftermarket carbs rather than fixing the factory- but this one worked great out the box no tuning needed.

I have a Subaru snowblower with an SX17 motor. The carb for that was a little over 100.00 !! I saw this carb for the EX17 for 19.00 and thought why not try it. It is a spot on perfect match!! It also came with 2 additional black gaskets that matched my snow blower perfectly. 2 pulls and it fired right up with no surge. The quality of this carb was as good as the Misumi carb that came on blower from the factory. Honestly at 19.00 I’m not sure how they make money. HAPPY HERE!!

All I can say is wow. My Rigid power washer with the Subaru SP-170 engine would not start after sitting a while. It has been getting progressively worse each time I used it, harder to start, and needing to run on almost full choke. I tried to take the old carb off and clean it up for over an hour and it would not run at all other than for a second on starter fluid/fuel down the carb throat. This carb showed up, I installed it, and it literally started on the first pull. I ran it hard for a full gas tank power washing a house and hardly let up on the trigger all day, and it did not skip one beat. I use stabilizer in my gas but it still must have past its life and went bad and gummed up the old carb. THIS carburetor is a quick easy fix, I wish I didn't even bother trying to clean up the old one. If this lasts for a few years and I need to replace it again for around $20 I will have gotten my money's worth from it. For the SP-170 Subaru engine this is highly recommended. I'll try to update this review in the far future as I pull it out seasonally.

2016 RIGID Subaru/Robin Pressure Washer This was a direct bolt in, however one of the gaskets did not match up correctly, and I got a FEL-PRO cut to fit gasket sheet to cut one to fit it based on the original gasket. The other downside is the Fuel cut off switch was messed up when I got it so I swapped the original carb's fuel cut off switch on this one (it was very easy) and the Pressure washer fires up every time 1st or second pull!. Barely any choke and it fires right up. Well worth the money and time cutting the gasket.

nice fit and function.

Used as a direct swap out with the carb on my Subaru mini bike engine. Started up first pull.

The carburetor itself is OK. BUT, the lever for the choke was missing and one of the two gaskets did not fit the carburetor.

Great value for the money. Easy installation. Fired up on the first pull. A small adjustment to the idle to eliminate surging, but that is to be expected.

Proprietary fit to the Robin engine, most often labelled as a SUBARU small engine...they are wonderful engines, that are NO LONGER made...so sad!

Good option to get an old motor running properly. Easy to install. Started and ran great on third pull with no setting adjustments.

Worked great no issues, shipping was faster than quoted

The order came in very quickly which was nice. Looks exactly like my old carb, so pretty much a OEM part for my Subaru Robin EX21. The gaskets were not exactly the same as the old ones in my case, but can probably be modified to fit. They are made of stiff plastic material. I used my own gas resistant gasket paper and cut parts identical to the old gaskets. I changed the gas line and the spark plug as well. The motor started on my first pull. Feels like a brand new machine.

It worked fine as a replacement carburetor for my Subaru pressure washer.