Shower Head Bracket-Chrome

El pegamento que trae no funciona, solo se mantuvo pegado 3 días y se cayó. El producto como tal se ve de buena calidad pero el pegamento no.

The shower head holder looks good and fits the showerhead as it should. However, the instructions were very poor. Managed to get it up, and it came down within a week. Now looking for a different adhesive so I can put it up again. Sooooo annoying!

This product works. Must not use it for 48 hours. After months I can't believe it is still up. The others I bought never held up to the ceramic.

This shower head holder is well made and is all metal vs plastic used in other holders. I particularly like the tight ball joint, as I have a heavy shower head and it will hold it in place. It has to be glued on and then held in place while it dries from 48 to 72 hours. It comes with light weight adhesive strips to hold it in place while the glue it drying, but I opted to hold it in place with duct tape (see attached picture). Now I know that when I peel off the duct tape in 72 hours, the shower head holder will be solidly adhered to my wall. I also found when I screwed of the cap on the tube of glue, I could not squeeze out any glue, so I just snipped off the top. The glue is light a paste, making it easy to work with and, even though it came with two tubes of glue, I only needed to use one. Be very careful to place the glue only where the pictured instructions tell you, as putting glue in the center of the adhesive plate will lock in the rotating ball. Also only put the glue on in small dabs, as too much glue will also lock up the ball rotating ball.

Again the contractors put the hand held shower holder too high. Bought this simple stick in holder the irks and looks fine. However had a little problem about an hour after gluing to wall the holder adhesive gave way and fell. I reattached it to the wall with a little more adhesive and this time used lots of scotch tape to hold it in place. Left it for a few days and binding was solid.