Frame Spring Wire Compatible with Ninebot by Segway Go Kart Kit Gokart PRO Refit Smart Scooter Replacements Frame Spring Line GoKart Original Accessories

Had the four tip end break off the previous cable on my gokart. This was a great replacement, works just fine, I just didn't route it through the body this time, just cut off the old cable and then zip tied it to the frame to avoid having to fish it through. Kart is working very well now, thank you.

Overall, this cable fit my Ninebot Gokart (Kit) and works as expected. The only challenge I encountered was reinstalling the rubber grommet that holds the cable in place at the front of the vehicle. After struggling with it for a while, I opted to zip-tie the cable to the frame instead. For anyone replacing the cable, I recommend using a Nylon Mason Line to help pull the new wire through. First, tie one end of the Mason Line to the old cable still in the Gokart, ideally at the front of the vehicle (since the rear connector is too large to fit through the front opening). Then, pull the old cable out from the rear until you see the Mason Line. Remove the line from the old cable and securely tie it to the new one. Next, head to the front of the Gokart and carefully pull the Mason Line to feed the new cable through. Keep in mind, the cable is springy and may retract if you don't secure it, which is normal due to the adjustable frame. As mentioned earlier, reinstalling the rubber grommet at the front was tricky for me, so I ended up zip-tying the cable to the frame instead. If you're looking for a quicker solution and don't mind some potential risk, you could also run the cable outside of the frame, but this could lead to damage over time.

Works when it works but need to be replaced more frequently