Holikme Garage Door Bottom Seal, EPDM Rubber Weather Stripping Kit Replacement, Threshold Ramps Seal Strip for Winter Freeze & Spring Rain Protection, 5/16 Inch T-End, 3.74 Inch Width (22Ft, Black)

I bought the 22ft roll for my 20 ft garage door. Many reviews say it's short by a few inches so I wanted to be sure I had enough. As it turned out the product measured almost 22ft +1 inch on an 85 degree day in Houston. The product was soft and pliable and well packaged in a roll.. Installation tips/requirements which helped me, your results may vary. It does take two people to install this seal in the track, one to pull and the other to bend the seal into the U shape and carefully guide the T-edge into the track. If not properly held and guided into the channels the T edge will come out. BOTH sides of each T must be in the channel to secure it properly in place. If one edge pops out you need to back up the seal until it is seated in the track before continuing with the installation. Failure to do this will cause the seal to fall out of the track later on. Be fore you start, make sure the track guide channels are clean of all sand and dirt as well as the rubber edges on the door seal. I had mud in mine which needed to be brushed out and wiped clean with a wet rag. Also make sure all screws that attach the track to the door are tight and fully seated to prevent the seal from catching them during the installation. I found dish soap/water did help in the beginning but dried quickly and stopped the seal from sliding in the tracks unless I kept the entire length wet. This goes for both the channels and rubber seal. I switched to a Klein Tools Clear Wire Lubricant used to help pull wires through conduit. This is a safe clear lubricating jelly and I found the rubber seal to slide much easier along all 20 feet. Also to assist with pulling the seal, I used vice grips to grab the seal and give something better to hold on to. I didn't see any ripping or tearing while using the pliers. In my case I had an extra two feet of seal if there was any damage. After the seal was installed I grabbed and slid the seal very slightly back and forth in the track to be sure there was no tight tension in one spot or looseness in others and did this along the length of the seal. The new seal is good and tight, no light showing through under the door. Pictures included.

Installed in minutes with the help of my wife on our 18-foot garage door. Very soft and flexible should last for years to come. Does a great job sealing the bottom keeping out dust and rodents. Very pleased with this product.

I had a new door installed nine years ago, but never thought about the door seal until I had the door open for painting. I saw the original seal was flattened on one end, and the rest was in fair shape. The decision was made to replace the seal and that's when I ran across the gem. Two days later it arrived and installed. The first thing I noticed when opening the roll was the highly pliable black EPDM rubber, which is the same material used in Fernco clay pipe couplers. The material is built for durability. The new seal sits higher than the original, so this required changing the down stop position on the garage door motor. Before I made the change, the motor felt the tension as the door came to rest and interpreted it as an obstruction, causing the motor to reverse. The position change took just a few seconds and now the door stops at the needed position and the seal fits tightly against the floor. Easy. What a pleasure it is to have a very high quality seal, and the knowledge that the material should last decades--unlike the OEM seal.

Very satisfied with the product. Good quality rubber and works better than I thought. I used Fluid Film to lubricate the garage door T tracks (no solvents or other harmful chemicals that would affect the rubber) and it went in smoothly. I would have like to have had four plugs vs two as I bought a long strip and cut to fit two garage doors. I used some of the excess trimmed seal to plug the ends of the 2nd garage door seal and it worked just fine. Happy with the results!

This bottom seal installed easily. My wife helped pull it across while I fed it from one side and pushed. I used WD40 as lubricant rather than soapy water or silicone lubricant (which I did not have). As this seal is thicker than my old one, I had to readjust the automatic garage door opener as it sensed pressure on the bottom an automatically lifted up. That was an easy adjustment, and the door sits properly on the floor with no gaps. Good product.

It took two of us to install but it wasn’t too difficult. The strip is pretty thick and appears durable. It does the job of preventing rain from seeping into the garage from under the door. Was easy to cut the excess with a razor.

I purchased this for an 18' garage door so I bought the 22' package. I first went to my local garage door people here in town, they wanted 58 dollars for exactly 18' of material. Not only was their price exorbitant, but the rubber was very thin & felt like it would last a year if I was lucky. So I went on Amazon and found this product. As soon as I opened the package I could immediately see & feel this was a MUCH better product. The quality of this rubber is thick, but yet soft and adaptive to imperfections of your garage floor. My wife and I installed it in about 45 minutes with no surprises throughout the install. The "T" part of the rubber fit perfectly into our rail on the bottom of our door. The only thing we did was after removing the old piece of rubber from our rail was take a brush from my dustpan and brush off the rail on the bottom of our door of dirt and debris. The measurements listed on their picture are very accurate as well. I am VERY happy with this purchase and would highly recommend this product for any homeowner that doesn't want to keep replacing it every 3 years or so. It is a quality product & delivers exactly as advertised.

This fit the tracks on my door when the one from the local home improvement store did not. I cut a 22 foot one in half for two single doors. Was able to install by myself with some patience and silicone spray. It seems to be high quality, and a much better seal than the worn out strips that were on there.