ECOELER PIR Ceiling Sensor Switch, Hard-Wired Occupancy Motion Sensor with Slim Design, 360 Degree Field of View High Bay Ceiling Motion Sensor, White, UL & FCC Listed

Easy install, great adjustments, works great.

I got tired of having to turn my garage lights on from the switch outside the door in my den, so I had my friend hook this up right next to a ceiling outlet that I daisy chained a few led tube lights that I mounted. Works great and does have a few separate adjustment knobs on the inside of the light in order for it to work the way you’d like it to. My only small complaint that I have and why I didn’t give it a full five stars is that this item does not capture a long distance well. After many adjustments, the best I can get out of it to turn on is when I’m about five to six feet from it. If your looking for something from a very far distance, I’d not get this product, but if it’s used in a smaller space, this will work fine.

I replaced a old pull string light switch with this motion sensor switch in a walk-in closet. The switch was easy to install and works great. I especially like the fact that you are able the adjust the amount of time the light remains on.

I found this one to replace my old sensor, which only has a maximum 7-minute delay. I found it easy to connect the wire and hang it from the ceiling. The only minor issue is that it is not easy to unscrew the cover to attach the screws.

The “Product details” states “Adjustable time delay from 15 sec - 30 min.” This is misleading and only partially true. The sensor will ONLY turn off at 5 specific set points (15sec in test mode, or 5min, 10min, 20min or 30min). You CANNOT set it to go off at any other times. If for example you want the sensor to turn the light off 1 minute after you leave the room, this is not possible. The shortest time is 5 minutes. If you put it in “test mode” it turns the light off every 15 seconds EVEN IF you are standing under the sensor jumping up and down the entire time. The sensor does work, just not as advertised. It’s disappointing that Amazon chose this sensor as their “recommended” choice.

I removed my old spot lights and added a couple of Juno LED lights. However still needed a motion detector to trigger the lights. I have been searching for an exterior motion detector that was minimal in size, nothing large or protruding. I researched this product, even though it says for indoor use, and it works like a charm. It is installed under the eave, so it is protected from direct rain. I also sealed all of the edges with silicon for added protection, so time will tell. Cheers, Danbo

Works ok but not a lutron sensor. Probably wouldn't buy again.

These sensors work but you have to play with the settings. A real low setting on the sensitivity level will shut the switch off if the movement stops so if you set the duration to a bit longer you won’t have the switch shutting off

Very good quality works well

Item works as described, easy to install

Works great. I like the 360* sensitivity. Works with no delay. Would recommend! Bought another one to replace a sensor that works in one direction only.

Easy to install in place of the previous sensor. Blends in with ceiling and works very well

I bought this to replace a Leviton sensor, since those now sell for about $70. This one is excellent value, build quality is decent and sensor works as expected. It goes from 15s to 5min, but that was not an issue for me.