Delonghi 5113211291 Water Pump

Perfect replacement for my ESAM 3300 Delonghi espresso machine. Found a tutorial online installation took only about 15 minutes. The new pimp is operating perfectly!

Worked perfectly for my Delonghi Magnifica. It was not pumping water- put this in and have espresso again!

In the past, we have had to send our coffee maker out for repair, one time costing about $375. This time I ordered the pump on my own. The installation was reasonably easy after reviewing a couple of YouTube videos. The new pump has been in for only about one week, but our machine works better than it has for years. When the pump is strong, it cuts down on the bitterness of the espresso, since the water is pushed through more efficiently.

Perfect fit, easy job to replace and coffee machine is back to new again.

I've been going through a list of possible issues in my Delonghi Rialto cappuccino machine for the "ground too fine adjust mill error." I had already started shopping for new machine when I found this affordable pump and thought I would try one last repair. Sure enough, it started working again. I didn't prime the pump before or after install like the other reviews suggest, but it completely purged the air from the system during the test run.

I've had a DeLonghi Magnifica ESAM 3300 since 2008 that had stopped pulling shots. I tried descaling multiple times and also cleaned some of the lines. I replaced the pump last night, which just required a screwdriver and pliers, and the machine seems to be back in working condition. Great to be able to avoid spending money on a new machine!

The part was an exact match for the LeLit Anna's water pump. It was easy to install and works perfectly. I found helpful installation videos on YouTube that made the job easy. I did not need to use a syringe to pre-inject water into the pump before installation.

Muy buena

Llego en tiempo y ya van varias que les compro, salen muy buenas.

Perfect replacement for dead pump on my 7 yr old Magnifica XS

Works like a charm and was an easy replacement. I’m glad I watched a YouTube video though as I might have pulled the wires that are glued to the pump too hard instead of breaking the glue.

Easy to install my coffee maker is brand new again

Very good original part. But be ready to take up to one hour to replace, lots of tubing and connections to remove to go to the pump. Not a easy task. Take a lot of photos to be sure to reconnect all correctly. Also you need a special bit to remove the back panel, sold on amazon as tamper proof bit set , a hex bit with a hole in the middle. But the end result is a Delonghi expresso (EC 860) working like new I do not understand how some reviewers were speaking of a 15mn job. The pump is exactly the same as the original, I guess only one factory in china is producing them.