Orion Motor Tech 3" 4" 6" 3-Jaw Gear Puller Set for Removal of Bearings Pulleys Flywheels

Muy buen producto excelente gracias

I've used them a few times now, so it's finally time for a review. First of all, I've worked as an industrial mechanic for decades (electric motors and various machines and such), and I've pulled something around a thousand bearings, pulleys, couplers, ect .. with every type of tool under the sun. In the months since I got these admittedly there haven't been any really good fights, everything I pull at my new workplace has been an easy pull. But that does raise a question as to wether some of these things would have come off harder with other pullers....like maybe these are exacting enough to pull more straight than other pullers or just dumb luck? Anyway, the quality of these doesn't appear overwhelming at first glance. They look like upper tier Chinese tools, but they feel much nicer. The lead screws are smooth (I probably should grease them a little now that I think about it), and the bolts for the arms stay where I put them, not too tight to move or so loose they flop around. All in all, I've no regrets - especially at this price. I wish the branding didn't look like such a blatant OEM Tools rip-off, because they can hang just fine as they are. I've also purchased a bearing separator and H-block set from OMT as well and my opinion of their tools stands for both that and the (3) 3-jaw set I have.... Do it, they're worth more than the asking price!

great tool

The pullers may not be as heavily built as the tools of yesteryear, however, their fit and finish is exceptional particularly for their reasonable price and more importantly they work! The 8” puller was immediately put to work pulling off both rear bearing hub assemblies on our BMW X3 and it did the job with ease. The three jaw design certainly makes setup and operation more convenient than my two jaw pullers. Great tools at a reasonable price! I couldn’t be more pleased with this purchase!

Used these to remove a very stuck belt pulley, and a couple of seriously corroded on bearings. Went a lot better than I thought it would. Plenty of leverage - wasn't even very hard turning the jack screw with a socket wrench. The pullers are made of hard steel. Not a mark on them when I finished the job I got them for. They come only partially assembled. No tools required to finish assembly. They can go together several different ways for inside or outside pulling, longer or shorter legs, and two different jaw types. Good set.