Corsair Hydro X Series XD5 RGB Pump/Reservoir Combo - D5 PWM Pump - 330ml Reservoir - Ten Individually Addressable RGB LEDs - Temperature Sensor - Black

Alright, buckle up because I went all in on Corsair’s waterblocks for my CPU, RAM, and pump, and let me tell you—I’m never going back to EK again. I’m talking about a triple threat here, and Corsair knocked it out of the park. First off, the price difference between Corsair and EK? Stupendous. I felt like I was getting away with a steal. But the real kicker? The pre-applied thermal pads that aren’t crap. No more scraping off factory gunk like a caveman with a butter knife; Corsair actually gives you thermal pads that make installation feel like a spa day for your PC. Life-saver? You bet! Now, I’ll admit the pump was a tad pricier than I’d have liked, but after a used one leaked like the Titanic in my rig, I wasn’t about to redo my hardline tubing. Corsair’s pump is rock solid—whisper-quiet, no drama, just cool, consistent flow like it’s training for a marathon. All in all, I purchased all three: CPU, RAM blocks, and pump, and I’m writing this single review for all of them because they’re that good. Quality is top-tier across the board, and I’m officially Corsair-converted. EK, who? With Corsair, I’m finally sleeping soundly, knowing my rig looks and performs like a million bucks without costing anywhere near that. Five stars to Corsair for water blocks that are surprisingly better, better-priced, and ready to turn your PC into an absolute liquid-cooled beast!

What I like most about this pump is that it comes with all the hardware you’ll need to install it in a case. My last pump was cheaper, but buying the extra mounting hardware was a pain and expensive. I loved that this pump came with all the screws and mounting brackets. It’s near silent at lower speeds, but can get a little loud at higher speeds. I keep mine at about 20% except for when I’m trying to get air bubbles out of the system. It should be clear that this pump does NOT require the iCUE Commander Pro for basic operation. I believe the manual says it does but that’s not correct. The motherboard can control the pump speed and even set the LEDs to a solid color if you have the right RGP connector. The iCUE adds the ability to use the included water temperature sensor and it greatly increases the amount of RGB customization options. I enjoy using the water temp sensor to measure the performance of my system and to adjust radiator fan speed based on those temps rather than the CPU temp.

I bought my first Corsair d5 based water pump it ran great no leak no trouble for 28 days. On the 28th day it started making bearing failure noises. Amazon sent me another at no cost and no down time for me, this pump is fantastic. Quiet, has enough pressure for my water blocks and radiator, It's a good looking pump, The RGB is nice and bright and you can always turn it off. The directions were clean and clear. I mean there's no better pump. And it's also one of the cheapest D5 based pumps you can buy, I will be putting these in all of my custom liquid cooled PCs from now on.

I love the look of this res/pump combo and it's powerful too with 800/L an hour. Its mounting is pretty versatile. Downside, I wanted to monitor water temps, only to figure out if need to buy another product. Never did that and it works fine, I just got off CPU temp. I haven't had leaked problems. The build quality is alright, the plastic looks kind of cheap but overall fine. Cooling is fine, I mean it pumps the water as needed.

Made my install very easy, as it comes with a mount, hardware, and even a temperature sensor which other pump/res’ you usually have to buy separately. It runs quiet, and has enough power for my loop. One con, the included philips screws to mount to a radiator only work with Corsair radiators as the diameter and thread pitch was different from my rads from another manufacturer, so if you’re going to mount it to a rad, check to make sure you have compatible hardware on hand. Other than that, for a basic to mid-level loop, I’d say this is the one.

Nice colors, solid pump, keeps pc cool

I came from the Corsair AIO 280 which had been a great performer for a few years now. But as I started to notice irregular temp swings, I thought it's time might be up. So I took the plunge into custom loop, and Corsair made this really easy. I went with the hydro X series, soft tubes, still 280 setup, on a 12700K pushing 5K-P/3.9K-E all core hitting around low 70'sC peak, around 30-33C idle. Around 65C after hours of gaming. Fittings worked great, easier with soft tubes for sure (better for beginners). Really quiet, works super well. Also, will work with ICUE commander XT (pump goes on fan header 6, then pick from dropdown menu).

It arrived with the air tube inside the reservoir just rolling around inside of it. Which in the design of this pump doesn't actually serve a purpose anyway as the coolant is only pulled from the bottom. I'd return it, but this rig isn't just some gaming rig and I really need it back in operation ASAP. Lucky for me the flow of the pump isn't enough to bounce it around...it just sort of sits there at the bottom while on and floats at the top when the pump is off...no rattling at least. If this was an actual "D5 pump" that thing would be be bouncing all over. So don't be fooled but that like I was in my moment of need. I have tiny pumps around with a far greater flow. The outlet appears to have a large space that must filled up first before it can pump. When bleeding it, air likes to sit in this pocket and even with the reservoir full of water and the pump being the lowest part of the loop, it will not bleed or pump. Nothing is labeled on the actual pump and my first thought was the instruction manual was wrong and I had hooked up to an inlet, but you can tell it is the outlet by looking in the hole...all the inlets let you see light inside. Turning it on and off repeatedly appears to slowly get it working, but the best way is to tip it a little bit side to side. Of course I didn't learn this until I had it mounted. As of the time of this writing it is still leak testing, but I don't think this should be an issue for normal operation...just is really strange. The housing has a big seam around it that is a major leak point. They also have holes all over it to allow for different configurations I assume, but I would have just rather turned it 90° then have plugs all over it that are possible leaks. Only one of these holes is an outlet so it isn't like you can have too many configuration options anyway. You can tell that RGB was their main concern rather than making an actual pump. Though if looks are the main concern...a bunch of ugly plugs don't really fit in.

Buena calidad de la bomba funciona bien, mueve 5 litros por minuto al máximo lo cual me parece poco pero funciona bien.

C'est une pompe D5 normal .. Mais comme je suis fanboy corsair ,je me suis appauvris de cette somme. Petit hic ,elle semble faire un raisonnement de tremblement sous les 2000rpm pourtant elle est fixé sur ses silentbloc d'origine et sur des Phanteks D30 qui ont aussi des pads en caouthouc anti vibration... Mise à part ça, très belle pièce comme d'hab chez Corsair

This water pump is absolutely amazing!! I bought this for my husbands computer and I was Extremely happily surprised when it proved it's absolute quality and power! It's actually quite pretty too!!

Köpte denna i god tro att Corsair skulle hålla bra kvalité den hade en D5 pump av känt märke bra prestanda "på papper" hyfsade recensioner så svårt att gå fel tänkte jag dessutom till ett bra pris fick mej att välja denna Två pumpar har packat ihop inom ett år den tredje lät som en mixer redan från start så tagit isär och dränerat loopen tre gånger jävligt kul.... Ny kylvätska tre gånger Köpa billigt köpa Dyrt stämmer här Så jag köpte en EK Pump Denna gång ok dyrare att köpa men hade jag köp den från början så hade jag inte haft allt jobb och krångel känner mej lurad på kostnaden för kylvätskan plus tid och arbete *loopen byggd med Corsair pump/block/radiatorer-EK kopplingar/rör Det enda positiva har varigt Amazon som har hanterat denna mardröm fantastiskt bra stort Tack till supporten !

I've had the Corsair XD5 D5 Pump for about 7 months now, when paired with the Corsair Commander Pro, you can use the temperature sensor to control pump/fan speed based on liquid temperature. The Corsair XD5 is quiet, easy to install and unlike many other D5 pumps, includes 120mm and 140mm fan mounting hardware, as well as a temperature sensor for one of the G1/4 fittings (requires a Corsair Commander to use) If you are in the market for an affordable, high quality and genuine D5 pump, I can highly recommend the Corsair XD5.