Readytosky RS2205 2300KV Brushless Motor CW/CCW 3-4S RC Motors for FPV Racing Drone FPV Multicopter

These work great! I have used 2 of the four so far and they are nice. Work like they should. 10/10

Ridiculous how cheap these were. All 4 motors worked. Only thing to watch out for - dont use different screws that are too long to mount into the stator. If you use screws that are too long you could thread them into the phase wires in the motor and that will cause motor funkyness and weird start-ups. I did this once and learned it the hard way. This is true for a lot of outrunner motors though, so this one motor in particular is great for the price.

I purchased these motors as replacements for my 1208 2300kv quad motors, and installed them with no other changes (using stock beta flight pids.) They work well enough, but are fairly under powered compared to the 1208s I had been using. Current draw is a fair bit higher, as expected, but downsizing from 2200mah to 1600mah fixes most of the issues (at the trade off of flight time.) 6 batteries in and I've not had any heat buildup issues. If you've got a really light 5" quad, these are decent motors.

For this price you really can't go wrong. If you lose motors to crashing more than burnout, these are your new go-to. I'm so happy with the performance at this price point, and it significantly reduces the fear of crashing. The Good: Reasonably balanced, reasonably quiet - better than I would have expected at this price. The Bad: 2 of 4 motors have a slight bearing rattle - very slight. For the price this is hardly a drawback. The Ugly: At this price I can't really complain that they aren't super-robust or don't last for hours of flight time. I haven't had them long enough to abuse them yet, but even if they get destroyed in a crash it's only like 8 bucks to replace one so who cares?

A reasonably priced 2205 motor set, for the price its not bad. The issues I had are that the leads are very difficult to solder too, I had to use a flux for aluminum to get the leads to properly solder too a mr30 plug. They also don't have prop gripper teeth where the prop mounts so slippage is possible.

These are poor quality motors. They cut-out periodically while flying. I’ve tried running them on multiple ESCs, propellers, batteries and aircraft but the problem is persistent on the three that I have used. After replacing the motors with equivalent, but less expensive, motors from other manufacturers, my motor issues are gone.

Quiet, powerful on 4s. Good motors so far, have about 20 flights on them now.

Great motors. Bought for a budget build to see if it was possible and it was. On 4s they do get pretty hot so be mindful and fly accordingly.

Leider sind 2 der 4 Motoren defekt und drehen nicht hoch, bzw stottern nur. Somit kann ich keine Angaben zur Funktion sagen, aber da andere ähnliches Beschreiben, scheint es hier massive Qualitätsprobleme zu geben, lieber 20-30€ mehr ausgeben... Im Video zu sehen 1x ein defekter Motor und 1x ein funktionierender.