Box4.32 x 3.74 x 2.17

These are not waterproof but maybe resistant. The quality is quite impressive. We used these for a Radio Club project and they worked quite well.

Good for electronic projects. I installed an AR40A 10MHz Rubidium reference inside. Easy to drill. Looks good.

This will serve you well as small electronics chassis. I purchased two and both were without any defects. The units are full enclosures with no direct venting but the case structure itself will serve as a heat sink for lower heat applications if you design your project properly. My application for these cases was for high voltage static discharge beta circuitry on RF feedlines. The entire case is sturdy. I would order them again if and when needed.

These are nice, but there is only one PCB slot. Not in the right location for my project.

Really nice case for the price. Gives my prototypes a nice appearance.

Very sturdy aluminum box. Edge panels are thin but that may be good as they'd be easier to drill. The top slides into place freely but some tape at the edges will make it stay in place even without the side panels. I used it to house Mobius cameras

There are very nice well made boxes. The sliding top adds a nice feature over the split box style. Very sturdy.

Worked as described!