Sea Frogs 130ft/40m Underwater Camera Housing Waterproof Diving Case for Sony A6400 with 16-50mm Lens (Housing + Red Filter)

Happy that this fit my camera perfectly. Yet to use it submerged, but it performed perfectly in a very wet environment getting up close and personal with Niagara falls.

When I put the Sony a6400 camera into the Sea Frogs housing for this camera, the 3 inch screen goes black. You can't see through the view finder due to the material the rear of the housing is made of. WHY??

Case is solid a bit on the heavy side. I purchased this for my camera but now have to purchase a new lens that will fit in the case.

To whom it may concern I’ve purchased your product from amazon KSA The product was shipped internationally from USA to KSA and then shipped to me in Egypt (wheelre I live) by another courier. The housing is for Sony a6400 with a specified depth of 40m. I used it as the manual stated First, I greased the the oil ring with a dedicated silicone grease as stated by the manual Second, I submerged it in a depth of 1 meter (housing only) for 5 minutes. The result was a massive leak which resulted in the damage of the water sensor (continuous beeping even after completely drying it) and all 24 divers on the boat was very annoyed by the non stoping beeping sound which lasted for nearly 30 min. So I disconnected the water leak sensor. After visually trying to inspect any visual faults I’ve found that the door lock mechanism doesn’t fully isolate pressure ( the gap between the door cover (the top part) and the housing itself (te bottom part isn’t linear and it increases towards the lock. In other words if you pressed with your finger with a firm pressure you’ll find it compressible by the force of a thumb from top and second finger from bottom. I tried putting a small zip tie on the place where the lock latches the click sound was much better and it sealed properly So I repeated the test once more only to find that the leak has decreased, but I was able to detect the leak is from the seal so I removed it. It came out stretching even I was removing it carefully only to find that the spare oil ring is impossible to fit I am completely disappointed it coasted me a lot shipping it and I planned a diving trip just to try this camera underwater which I bought the casing for) Thanks in advance, please do read the message carefully and provide useful solutions