Which skin type is it good for?
✔ Normal
✔ Oily
✔ Combination
✔ Dry
✔ Sensitive
What it is:
A sweat-resistant, translucent formula that smooths skin’s
appearance and reduces shine.
Solutions for:
- Dullness and uneven texture
- fine lines and s
- Oiliness
If you want to know more…
This refill for Invincible Setting Powder SPF 45 is a 100
percent mineral, sweat-resistant formula perfect for reapplying
broad spectrum UV protection throughout the day. It sets your
makeup and reduces shine, while smoothing the look of skin
texture by diminishing the appearance of pores for a soft-focus,
matte finish. Use it again and again: the ultra-soft, luxurious
brush (sold separately) is washable and detaches easily from a
refillable base.
What else you need to know:
This product is cruelty-free, and does not contain synthetic
fragrance or oxybenzone. All Supergoop! products have been
clinically tested and determined to deliver broad spectrum UVA
and UVB protection.
Clean at Sephora
Clean at Sephora is formulated without a list of over 50
ingredients, including sules (SLS and SLES), parabens,
phthalates, and more. For the full list, check out the
Ingredients tab.
* Suggested Usage:
To refill:
-Unscrew the jar at the bottom of the brush (sold separately) and
load the refill by screwing on until tight.
To apply powder:
-Gently tap brush against your wrist three times in order to
dispense the proper a of powder.
-Apply liberally and evenly to face before sun exposure.
-Reapply after 40 minutes of swimming or sweating, and
immediately after towel-drying, at least every two hours.
To clean the brush head:
-Pull the brush from the magnetic base and wash with mild soap
and lukewarm water.
Tips:
-After opening, remove and did the plastic pin at the center
of the brush.
-Tilt and tap the brush gently against your wrist until you see
the powder start to flow through the bristles.
-When your makeup is ready to go, brush the powder generously
over your face to set the look and mattify your skin.
Precautions:
-For external use only.
-Do not use on damaged or broken skin.
-Stop use and ask a doctor if occurs.
-When using this product keep out of eyes. In case of eye
contact, rinse with water to remove.
-Keep out of reach of children.
-If swallowed, get medical help or contact a poison control
center right away.
-For use on children under six months, ask a doctor.
-Protect the product in this container from excessive heat and
direct sun.
Ingredients
* -Zinc Oxide 24.5%: Delivers broad spectrum sun protection.
Calcium Aluminum Borosilicate, Silica, Polymethyl Methacrylate,
Ethylhexylglycerin, Triethoxycaprylysilane, Nylon-6/12, Sodium
Dehydroacetate, Olive Glycerides, Ascorbyl Palmitate, Ceramide 3.
May Contain (+/-): Iron Oxides (Ci 77492, 77491, 77499), Titanium
Dioxide (Ci 77891).
Clean at Sephora products are formulated without:
SulesSLS + SLES, Parabens, Formaldehydes,
Formaldehyde-releasing agents, Phthalates, Mineral Oil, Retinyl
Palmitate, Oxybenzone, Coal Tar, Hydroquinone, Triclosan,
Triclocarban, Undisclosed synthetic fragrances (Products can be
formulated with disclosed synthetic fragrances that meet the
following two criteria: (1) the synthetic fragrances do not
include any of the ingredients listed in numbers 1 through 12
above and (2) the synthetic fragrances are at a concentration
below 1% of the total formula) The following type of acrylates:
(ethyl acrylate, ethyl methacrylate, methyl methacrylate, butyl
methacrylate, hydroxypropyl methacrylate, tetrahydrofurfuryl
methacrylate, trimethylolpropane trimethacrylate , aluminum
salts), Animal Oils/Musks/s, Benzophenone + Related Compounds,
Butoxyethanol, Carbon Black, Lead/Lead Acetate, Methyl Cellosolve
+ Methoxyethanol, Methylchloroisothiazolinone &
Methylisothiazolinone, Mercury + Mercury Compounds (Thimerisol),
Insoluble Plastic Microbeads (This prohibited ingredient applies
to products that are meant to be rinsed off ), Resorcinol, Talc
(Talc that is free of any asbestos can be used in the formulation
provided that Brand conducts testing to ensure that talc is free
of any asbestos.), Toluene, Butylated hydroxyanisole (BHA),
Butylated hydroxytoluene (BHT) that is 0.1% or more of total
formula, Ethanolamines DEA/TEA/MEA/ETA, Nanoparticles as defined
by the European Commission ( http://ec.europa.eu/growth/sectors/cosmetics/products/nanomaterials_en ), Petrolatum and Parrafin that is not USP grade, Phenoxyethanol
that is 1% or more of total formulation, Polyacrylamide &
Acrylamide, The following types of Styrene (Bromostyrene,
Deastyrene/acrylates/dvbcopolymer, sodium styrene/divinylbenzene
copolymer, styrene oxide, styrene), 1,4 Dioxane in final formulas
must comply with the thresholds as follows: (10 or < ppm for
products that are meant to be rinsed off, wiped off or removed,
3ppm or < for products that are meant to remain on the skin).