EZ-Fluid 1/2" FIP Female Iron Pipe X 3/8"Comp X 3/8"Comp 1/4 Turn Double Handles Dual Outlet LF Brass Angle Stop Valve Water Shut Off Ball Valve For Water Pipes,Faucet,Toilet Valve,Icemaker,Filter(1)

Kitchen renovation. New fancy sink that you need an advanced degree in quantum physics to install. Had to change out the existing shut-off valve under the sink to add a new water line to the cold water filtration on the new sink. Works exactly as expected. Thought the connectors on opposite sides would be a problem, but actually works really well as long as your feed lines are long enough. Water works, no leaks, minimal amount of swearing, but that's moreso on me than anything with this shutoff.

Very good quality and it works perfect. Make sure this is what you want. Because it's not a compression valve, it looks the same, but if it's what you want, it works perfect.

I needed another 3/8" comp outlet for a dishwasher, and replacing the single-outlet valve with this dual-outlet valve was the simple solution. I removed the old valve and cleaned the threads on the pipe from the wall, and then wrapped the threads with a quality PTFE tape and installed the new valve. Some reviewers noted the lack of flats for a wrench on the valve body (where it attaches to the outlet pipe from the wall). My solution was to remove the compression sleeve from one 3/8" valve outlet, and then re-install and fully seat the compression nut. Rotate that valve handle to its "closed" position to get it out of the way. Next, use a large enough adjustable wrench to seat against the top of the nut and rear of the respective valve. You'll be able to turn the valve easily rather than relying trying to grip the round valve body. It's a solid well made valve, and the quarter turn valves showed no signs of leaking.

Works fine

Works great. For the life of me I can’t understand why anyone would still buy a multi turn valve instead!

I really like this type of quarter-turn shutoff valve which is commonly available for a single shutoff. This valve is the best when wanting a separate hot water shutoff for the kitchen faucet and the dishwasher.

I should have taken a picture of what was done prior from the old owner of my house. These are great to clean it all up. Both hot and cold had 1 “T”, 2, 1” nipples, 1, 90 and 2 gate valves with 2 fittings to the 3/8 compression fittings? WTF? What a mess it was! Now it’s clean!

Well made with one minor flaw. There is no hex or flats on the pipe fitting side. This leaves you to have to use pliers to tighten it fully which will mar the surface even if you are careful. Other than that, it’s a good valve set.

Je n’ai reçu qu’une valve sur le lot de 5