Ximimark 2Pcs Digispark Kickstarter Mini ATTINY85 USB Development Board Module for Arduino IDE 1.00

Worked perfectly. No complaints. Didnt remember digisparks being this expensive but these were about the cheapest.

Unfortunately, these were not recognized by my computer, and the seller was not able the give me drivers. I searched online and was not able to find drivers.

Summary: if you REALLY REALLY want/need to use a digispark, these ones have been great to me, a lot of hit or miss with other suppliers, nicely packaged AND!! THEY WORK!! i've used a lot of digisparks when they cost me $2 each, these ones really are GREAT, but now that i have to spend $4 to get a digispark that works, or buy 5@$2 and hope one or 2 work, so all-in-all, i think i'm done with digispark, but if do use them, i want once that works, such as these. These worked great for me. Many have issues with the bootloader not being burned, or funny stuff like you upload a sketch, the sketch works great till you disconnect power, leaving you testing and reuploading, and retesting. these worked absolutely perfectly, as far as a digispark goes, however if it cost $4 for a digispark that works without defects, well i can get a nano that works without defects for that price, have over twice the pins available, and frankly...digisparks seem rather delecate, perhaps its the way they boot-up, then run the sketch, but i think i've messed up the bootloader software by pressing a button that was on pin 3 or 4, so maybe i could fix this by reuploading the bootloader, but mostly i just avoid pins 3/4 now, and pin 5 is your soft reset, so if you use it for just about anything, you reset your digispark. So, great digispark for $4 i guess, but i've never even killed a $4 nano, with less headache, more pins, on-board programming chip, actual reset button, actual reset pin, actual usb debugging/serial monitoring, and as an added bonus, i can test the nano and push a new sketch onto it without unplugging it, but digispark, i get that usb device connected tone/ding, in, then out, modify sketch, plug in, then out, hmmm....nothing happening, plug in, reupload sketch, then out, now it works, but i have to change something again....

I ran into trouble with these not being recognized by my Mac as well as ArduinoIDE, Wasn't able to find any drivers online and I was not able to get them to work on my own, I am no means an expert with programming or troubleshooting so I can't say if its just my fault or the product so ill rate It 3/5.

It is kind of tricky to find the programmer driver for Arduino IDE. I finally made it work.

Programs directly from USB no jumpers,breadboard or external board.You need Arduino IDE 2.3 and digistump installed.

One of the two did not work. It had issues being programmed. Sometimes it seemed to work but most often it would come up with some sort of error: ">> Run error -1 has occured ... >> Please unplug the device and restart the program." and then sometimes the sketch would work and sometimes it wouldn't. Even with a basic blinky sketch. The other one worked fine. I only needed one so I guess it will do.

After program it, and unplug/re-plug back to USB port it still remember it's code. Yeah!!! This device has correct version of pre-installed bootloader, so it can work with USB cable right out of box without using Arduino Uno/nano to as programmer. I give it 5 stars because it works with USB cable right out of box. So happy purchase this board...

All as advertised. Came a lil slow due to postal service. good product, good seller and good communication from seller. Will buy again if needed.