Motorcycle Hand Grips with Bar End Cap, Racing CNC Aluminum & Soft Rubber Handlebar Universal for 7/8"(22mm) Handle Bar

They actually work pretty good, but be careful not to scratch them up installing, the black paint will scratch easily if you drop them or something. The end cap actually threaded into the existing threads on the clipons for my SV1k, I was still going to just use them without caps if I needed to but they worked fine. They look good too, but I haven't ridden with them for a long time yet, but the price is worth it even if they only last a year honestly.

Used these to replace the old, worn rubber grips on my 1981 CB750C. Size was a perfect match for 7/8" on the clutch-side and 1" on the throttle side. I did need to cut down a little of the plastic off the throttle, since these were a hair shorter than the originals, but it was a very quick modification. For the price, it was a no-brainer to make my handlebars look cleaner/more modern.

Cosmetically, great grips. Functionality? They failed to impress. They look great, but there is ZERO grip to these “grips”. They’re also extremely thin, so I think that contributed greatly to the hand cramps I got while riding with these. Lastly as a side note, the “bar ends” are just bolted into the rubber. Like I said, great looking and would compliment a project bike; but if I would advise spending a little more for more confidence in the ride.

Liked the product,, Would buy again

This did not fit over my 2020 Grom SF's throttle tube. I had to sand off the flare at the end of the plastic throttle tube as well as all of the little ridges. Only then would the grip slide over the tube. I also made sure to tighten the nut on the bar ends before installing the grips, but I am concerned that the nut will loosen and start free spinning over time, and it will be impossible to reach the nut once the grips are installed. The design could have been a little better in that regard. Once they're installed they do look and feel nice.

Simple put it works as advertised and installed as advertise

These are great grips. I installed custom handlebars 7/8 inch on my Yamaha bolt C-spec and these grips fit just fine. the only thing you have to keep in mind is that the end of the grips is fake but that doesn't bother me. my glove used to slide on my original grips which made me have to squeeze the handlebars more. with these, my hand is more relaxed because they stick to my gloved pretty nicely.

They look just like the picture but the end doesn't screw into a bar end and is just a cap screwed into a rubber piece, so you get a loose wobbly end hanging off. I just cut the end off and installed a solid bar end, it's rubber all of the way around so it was easy to cut off.

Schöne Griffe past ok was soll man schreiben alles ok leichte montage man kann sagen kinder leicht flutscht rein ohne Probleme

Moin, Optisch machen sie auf den ersten Blick einen guten Eindruck, das war es dann aber auch schon. Habe bei dem Artikel gedacht das Alu wäre auf der ganzen Länge verarbeitet,ist aber Leider nur an den Enden. Was ein Aufziehen auf den Lenker nicht gerade vereinfacht.