QC3.0+5V 3A Dual USB Power Socket, Quick Charge Car Charger USB Adapter for Smart Phone PDA Android GPS Use for Toyota

2013 Corolla. It was type A. Fitting beautifully

I replaced the aux socket with this fast charger. It works great. It took me about 45 min to install it. I had to tap cigarette lighter cables to get the power. Not at problem at all. Fits right.

Product works great and fits the slot in my 2015 Tacoma next to the raído aux input. Wired mine to stay energized all the time. And added extra fuse protection. And has a light blue light on it that some might not like. But it works for me.

Fits perfectly inside the glove box of our 2020 Toyota 4runner Off-Road! There's a factory blank/space cutout inside the glove box, right above the interior cabin filter access door. Popped out the blank and this dual USB piece fit perfectly in that place. Tapped the wiring to the existing 12V cigarette ports wiring. Works as advertised.

Here are the dimensions so you may make an informed decision. The face is 22mm x 33 mm The rear block is 18mm x 23mm Depth of the face is 9mm Depth of rear block is 45mm The overall depth is 54mm Overall build quality looks great. I was unable to install because the dimensions didn’t work out for me.

Do not buy this unless you have easy access to replace it. Installed it in my 2007 Toyota Tundra. Had to wiggle the wires behind the dash to get it to intermittently connect. Product feels cheap and flimsy. Would not stay powered without holding the wires in a certain position on the back of the USB. The barbed tabs are large and don’t have room depress/release when installed into the standard size Toyota Dash knockout. Would have rated it zero stars if possible.

Functionally, it's fine. It puts out a very stable and steady 5 volts, so it should have no risk of damaging your devices. I question the claim that it supports QC 3.0 as I have plugged devices which should support that standard and saw no difference compared to the other port which purports to be standard 5v 2.4a. I suspect both ports are identical as I have disassembled this (more on that later) an the two ports are each separate board which appear 100% identical. It has two very annoying blue LEDs that are on not only when it's in use but any time it's receiving power from the car.. Make sure to wire this up in a way that will not receive power when the car is off as those blue LEDs will slowly but surely drain your battery. One of the two ports is upside down, so keep that in mind as it could affect device compatibility if you want to plug in something with a very bulky cable or a device with controls you'd like to use (something like a first-gen iPod shuffle would be tricky to operate via one of the two ports). I am on my second one of these. The first didn't quit working electrically but it wasn't held into its housing very well and an attempt to plug in a plug upside down just pushed it right out the back. So I had to replace it. This time I opened it up to remove the annoying blue LEDs and to reinforce the device structurally with some hot glue. While I was in there, I looked at the construction. The wires were thin, the solder jobs were shoddy at best, and the controller IC is under an epoxy blob so you can't see what it actually is. It's built cheaply but it does work and seems to be correctly regulating the voltage which is all you really need. If you have the skills to do so, I highly recommend opening it up before installation and reinforcing with hot glue, both to protect the shoddy solder joints and to keep it from falling apart. I can't exactly say that I recommend it, but there aren't many equivalent products out there that are any better, so if USB ports that fit in this specific slot size are what you need, well, this is what you're stuck with.

Was looking to add USB ports to an Audi A5. These worked perfectly