Compound Bow Press Archery Ratchet Bow Press Portable Universal Compound Bows Changer Tool Accessories for Shooting Hunting (Yellow)

I don't want to spend $400 plus on a bow vice to work on my one bow a couple of times, so I got this instead and it worked. Using this for my hoyt powermax. The square ends of the brackets that go over the limbs look and feel kind of sketchy, but I went slow, one turn at a time every 30 seconds or so and just kept checking to make sure they weren't slipping. I only tightened it down just enough to barely get the string off to add the extra twists I needed and then put it back, I also waited 5 minutes after loosening up the string before I started to try and take it off, jut to make sure the brackets weren't slipping off the limbs at all. Each time I use it I get more confident with it, but I don't think I'll ever be able to fully feel that its a safe tool. The instructions show the brackets going over the top of the strings, but everything in my head says that is wrong so I put it between my string and cables instead, worked great for me, I don't know why you would want to put it over top of the string like shown in the picture, makes no sense. I also took the string stop off my bow before using this so that it wasn't in the way and would recommend you do the same. All in all it worked on my powermax and didn't cost me a bunch of money or space. I will recommend for my bow and others with similar limb angles, size, and spacing, that just need to do a once in a blue moon correction.

Bow press worked great after I added some tape to one of the forks! One of the forks was missing the rubber coating and the one almost slipped off at full press. Super sketchy but once I added some grip tape to the one missing, it worked great!

Easy to set up and use. Had my jumped bowstring back on and shooting 15 minutes after it arrived. Make sure you back off the limb weight.

This is the most dangerous and sketchy pow accessory or tool I have ever seen. It is not constructed for safety, and the instructions are terrible. The split limb adapters slipped under pressure following the directions, and they did it twice under severe pressure. I decided to stop before someone got hurt or something broke. DO NOT BUY THIS ITEM. It has the potential, when used correctly, to maim you, those around you, or destroy your bow. This is a total garbage item to avoid. On close examination, the screw block (aluminum) warped with just two uses.

A little intimidating at first, but worked very well. Did have to use a socket wrench on one bow. Didn't have to on my other one.

This should be used for bows where the limbs aren't close to parallel. Regardless, the hooks are 90° so there is still a risk of it slipping off regardless. I worry that if the hooks were to deform a little bit, slippage would be a problem. This product works for me, but it barely gets a pass. Chose this over the other ratcheting products because I worried about the release system of the ratchet.

I got a press, but one bow gives me trouble , I use it as a backup sorry safty

They do ok for an emergency... But the black parts that hook on to the limbs bend... And use a socket and ratchet to tighten it up,,, a wrench makes it a pain in the but..!!!