Engine Support Bar 1100 Lbs Capacity Engine Transverse Bar Engine Hoist 2 Point Lift Holder Hoist Dual Hooks, Engine Hoist Keeps Engine Stable for Home Garages & Auto Repair Shop

Easy to assemble and use. Worked as it should and uses bearings to on the handle ends.

First used today. Does the job. To me this does not seem light duty, nor heavy duty, but pretty much status quo as automotive accessories go. Found myself nodding up and down saying yeah that should do it. There is a round washer full of bearings underneath the top clamps. I put a ton of grease and vaseline on the threads to reduce friction, especially since the threads catch on themselves a lot and are kind of rough. There is no hook or attachment included to connect chain to engine so I picked up a 3/8" Haulmaster quicklink rated at 600 lbs and custom ground/drilled a steel bracket to bolt to an engine attachment point.

best tool ever for motors and tranys so much better then a 2x4 and a ratchet strap

Works as it should. BUT get new bolts for the legs because the ones included are low level steel.

HARDWARE IS ABSOLUTELY CRAP!! AVOID AVOID AVOID. Bolts are too short stability is trash. Folded over under load. Luckily safeties were built into the project and no one was injured. Every nut/bolt/chain should be replaced before use.

I received product with unbroken package. Everything is in the box. The bar is heavy and strong. The washers are big and thick. They hold the legs tight for safety. Two bearings between the screws and bar making it easy to turn. This product is heavy duty. It is recommended

Worked on a 2008 BMW.👍

While the support does work for its intended purpose, repairs were necessary in order to complete assembly. Internal threads in the "standing blocks" were damaged by weld spatter and required retapping; external threads on the "adjust screws" were damaged in handling and required thread chasing. Damage to external threads occurred prior to shipping, as the parts were well packaged. The channels for the "rubber cushions" in the base of the "standing brackets" were too wide and uneven width; they would not retain the "rubber cushions", requiring the channels to be compressed in a vise to the proper width to retain the "rubber cushions". There are supposed to be 4 large washers, two with larger center holes, but I received three with smaller holes and only one with the larger hole; I had to ream out one washer to fit. Instructions make no mention of lubrication for the "pressure bearing", which is an open ball bearing, not enclosed/sealed. I rated it with 3 stars because it does work, but only after I spent an extra 2 hours or so on repairs in order to complete the assembly.