TC-KP48S

I picked this up to replace my Cat6A punch panel and have absolutely zero regrets. This panel is thick and is durable while still being very functional. There is no flex and it fit exactly where I had my existing panel. I pulled all new Cat8 22awg so I opted to use CAT-8 Shielded Keystone Jacks with a metal shielded housing from kwmobile and they fit perfectly and clipped in snug. The cable support in the rear is a nice touch as well over the plastic clips that my existing panel had.

Been using these to wire my home with cat6a. Mostly overkill but they are very easy to install. Make sure you're not seating the wire too far up or else you'll end up creating shorts in your wiring. Nice room to make sure you can bend each wire into its designated slots. I keep coming back to buy more when I want to do more runs. Here's a little bit of what I got going on in the server rack using these and I have them all over the house in rooms.

Worked great!! Originally used a cat6 keystone and could not get the performance I needed from a cat6a cable run until I used this keystone on both ends!

arrived a bit warped but otherwise really high quality

I use these, in conjunction with Cablematters Cat6A keystone female jacks, and with a MonoPrice 1U wallmount bracket. PRO: +rigid! no twist, nothing floppy, quite sturdy. +Inexpensive! +fits any type of jack / port on Keystone. This includes: Ethernet (8p8c, RJ45), Type-F (TV) Coax, HDMI, BNC, etc. etc. +Grounded (includes ground cable) for improved signal quality from grounded keystone jacks. CON (honestly none): -ground screw is quite small, when most ground terminals are much bigger. Even the bigger end is fairly small. (but this is sufficient for a signal-level ground). -support bracket has to be bent to be removed (but this is typical) -zip-ties included are only enough for ~24 ports (but that's how many ports this bracket has, and if you make mistakes that's your problem).

It's a 1U patch panel, what else can be said? Keystone jacks connect up easily. It's designed for using STP (shielded) able and has fixtures to allow grounding each cable. I haven't filled it, not sure if I will. It was worth the expense and would buy again if needed.

These are cast alloy housings with serious shielding. They are well built and the tool-less feature actually seems to be designed very well. I generally use CAT6 for everything, but occasionally I need a backhaul or extension between network rooms and this, combined with shielded CAT6a cable, seems to do great. Passes certification and haven't had any problems with them yet, but I have only installed about 6 or 8 of these in total, while I have used thousands of the plastic CAT6 ports. But initial impression is that I am very impressed with them.

It's a patch panel, does what it needs to. Fit is fine. Quality is fine. Rear is labeled for tia568a/b