BOSS Audio Systems MCBK420B 3 Inch Motorcycle Speakers and 2 Channel Amplifier Package - Bluetooth, Weatherproof, Volume Control, ATV UTV Compatible

Quality product! Sound is awesome for a $60 system, at 40mph and lower its great. It's plenty loud enough, but as you approach 60 mph and up truth is no stereo is going to sound like a home audiophile system. Bottom line is 'buy it'! Customer service is first rate, they are great! Also, I read some complaints about bass. When I first connected the speakers they too sounded a bit flat. I clicked onto my Poweramp music player and set it to large concert hall and max bass and presto... truly impressive rich sound! My install - I mounted the speakers on the handlebars just inside the windshield. Then, ran all the wires and the amp into a small, front fork mounted, 'tool bag' type pouch. The main issue is the red hot wire. I must have watched a dozen youtube videos on this subject. I usually ride with my high beam on. I know its obnoxious, but down here in Florida anything you can do to stay visible is a life saver. I unscrewed the chrome cover that holds the daymaker headlight in place. Sadly, Harley does not provide an auxiliary wire in the headlight wiring harness of Sportster's. At least not in mine. There are three wires entering the headlight assembly from a hole in the back. Black wire is ground, white wire is High Beam, yellow wire is Low Beam. I used a plastic splice connector from Home Depot to connect the red Boss power wire to the white High Beam wire. (AMP Splice Tap Connectors 10 pack). The hole in the back of the headlight assembly where Harley runs the headlight wires - Harley runs the wire harness though the hole with a rubber bushing that protects the wires and keeps water from getting in. I tried to slice the rubber bushing so that I could add the Boss red hotwire but it was cramped quarters and I couldnt get in there without taking the chance of cutting the headlight wires also. You may be able to do it, I couldn't. I ran the red power wire through the hole and at the point where it touched the metal headlight housing I covered the wire with an extra couple of layers of electrical tape to protect it from the housing wearing through the insulation and shorting the amp. Then, pushed the rubber bushing back into the hole. It wasn't a perfect fit, there was a slight gap because of the red wire I installed. It also wasn't a terrible fit - and then I put the headlight and headlight retainer back into place. After continual testing at every stage, and when I was sure all worked as it should, I used a dab of black silicone caulk and filled in the gap between the rubber bushing and the outside of the headlight assembly. This also helped hold the red power wire in place and reduce any chance of shorting against the headlight casing. I ran the ground wire outside the headlight housing for a few inches to a windshield mounting bolt and tightened it down. (I didn't want the ground wire taking up space going through the headlight hole, so I split the red power wire and the ground wire before the power wire entered the headlight housing hole. You may find it works just fine running both wires through, especially after using caulk to close up the hole where the wires enter.) Finally, I used zip ties to connect the volume button to the left side windshield mount, very close to where my hand naturally fits onto the handlebar grip. I believe you want the volume control where your left hand can safely get to it without too much reaching. Final result is my Boss audio system works only when the high beam is on. And when the bike is turned off there is no chance of the amp staying on and draining the battery. Also, my install required no drilling, no running wires under gas tanks and seats, and no toggle switch. I love having music now!!! Safe riding!

I wanted a system that would give me clean music at normal listening levels and that would not draw excessive amps doing it. My Mule, and most motorcycles have batteries and charging systems are not designed for excessive amp drain. ( the Boss Audio MCBK420B only draws 4-5 amps) . I chose the Boss Audio MCBK420B Bluetooth system for my 2019 Kawasaki Mule and I am very happy with my choice . I installed the amp inside the glove box. In the dash mounted the volume control along with an additional on/off toggle switch. The 12v power is supplied thru a relay that is activated by the ignition switch per the instructions. I added the fore mentioned SPST toggle switch inline so I can manually turn off the amp when not needed. The speakers are clamped to a round frame under the dash that allowed them to face the occupants. I secured all wiring with ty wraps. This system is just what I was looking for. Music is clear, clean and it will play louder than I care to listen. The bass is a little lacking but sound quality is excellent for this size speaker system . Great bang for the buck and easy to install. The amp , speakers ,mounts and wiring in the kit are all good quality pieces and instructions make it relatively easy to install. If your looking for a nice minimalist sound system to enjoy some tunes in your UTV or SxS I would recommend you check this system out. If your looking for bone shaking bass and enough volume to scare the animals this system is probably not going to meet your needs. Happy Trails

READ FULL REVIEW!! I have seen a lot of reviews on here about the bass and sound quality not being very good and I have to say do not let the reviews lead you astray from what these really are, great speakers at incredible price. You get great sound on a budget. The highs are crisp and mid range just as good. I was at 85 with cross wind with the volume half way and I had no problem hearing these speakers. I have stock exhaust so not incredibly loud. I agree that there is nearly no bass. But these are not $300 kuryakyn speakers or Rockford Fosgate. The install was very easy. I would recommend either having a second set of hands when mounting the speakers to the handle bars (which I did not have) or using a pliers or vice grip and bend the clips around the bars first. Wiring was a breeze. I went right into my ignition wire and turns on and off when I turn the key. Amp went under my seat. I am not kidding when i say that the bluetooth is incredible. It instantly connects to my phone withing 3 seconds of being powered on. Delivery was 2 days. Kit comes with everything you need to mount and enough wire. Took me one hour to do everything and I am not very experienced. Good luck! I recommend these speakers!

Great quality, sound and price! Not much bass so I pair with the Boss Slim8. Perfect!

Very Loud, but no base. I still liked them

Haven't installed the unit yet but I had the exact system in the past and the sound quality was great and the installation was a breeze for diy. Highly recommend.

Speaker mounting broke within a week of installing them

Easy install, louder then I was expecting sound quality is high on the highway at 120km/h in 55km/h winds I was still able to hear my music and enjoy it without turning the volume all the way up

Speaker's fitted professionally. However drained my new battery so had to pay for an additional on/off switch. Sound quite loud but could do with a lot more bass. Also impossible to register warranty as American company.

Easy to install

Hasta ahora todo bien! Solo debes poner un interruptor para que no se baje la batería pero sonido muy nítido y con calidad. Complementamente satisfecho igual esta un poco complicado poner los soportes de las bocinas pero una vez que tienes la forma correcta todo bien. Recomendado tengo Sportster 883.