Subaru BRZ Front Right & Left Bumper Bracket Set - 57707CA040 & 57707CA050 - Genuine OEM

Didn't fix the issue, but it was my bumper at fault for the issue, not the brackets.

came very fast. the exect product fits perpect

It worked perfectly for my Subaru BRZ 2015. Highly recommended.

This is marketed to stop the bumper sag that the brz front bumper gets. Unfortunately, the part of the car causing the sag is on the bumper and not attached to the body. As I took apart my front bumper and removed it, it was obvious that the tab on the bumper, not the body bracket, was cracked. These are pretty fragile and appear to be affected by age, heat, impact and possibly even looking at them the wrong way. The part needed is to support those fragile tabs. I went so far to go to the hardware store and attempt to fabricate supports out of metal, but found another solution that is all metal online elsewhere. Very pricey, but I don't expect to have to mitigate the gap again once installed. These are going to be great if your car has these and they're cracked, but they are just part of the bumper sag which is most likely in the bumper tabs.

Only giving 3* because they technically fit, but these are the old design and will NOT fix the saggy bumper much if any.

Fairly easy install, just removing the front bumper, unscrewing the 10m bolt and pulling out the locking pins. Subaru just did not design the bumper properly and all of the push pins and locking clips in the world will not fix. You need to go with quick disconnect, or switching to a metal locking pin system. $13 to reduce the sag slightly is not awful though, but will probably break the first time you decide to take it off.

Eliminates a lot of the bumper gap, not all though